1. People/material flow assessment arrangement:
Must check the material and the flow of people inside the set of clean spaces.
2. Determine the classification for the cleanliness of the space:
It is very important to know the primary cleanroom classification standard and what the particle efficiency requirements are for each cleanliness classification at the time of selection. There are different cleanliness classifications (1, 10, 100, 1,000, 10,000, and 100,000) and allowable particle counts of different particle sizes given by the Institute of Environmental Science and Technology (IEST) standard 14644-1.
3. Determine the pressure on the space:
It is difficult to maintain order in a space when it has a neutral or negative space pressure. What should be the space weight difference between spaces? These examinations found a weight difference of 0.03 to 0.05 in a wig. to be viable in reducing contaminant invasion. Bulk weight differences over 0.05 in. wig. try not to provide better dirt penetration control than 0.05 in. wig.
4. Identify the room's supply airflow:
Looking at Table 3, each clean air classification has an air exchange rate. For example, a class 100,000 cleanroom has a range of 15 to 30. The cleanroom air exchange rate should take into account the expected cleanroom activity.
5. Identify air flow by exfiltration from the space:
It is important to note that the rooms are not sealed and that they are spilled. All around fixed cleanrooms, the leakage rate will be 1% to 2% by volume. Is this leak terrible? Not.
6. Identify the air balance of the universe:
It is important to note that the rooms are not sealed and that they are spilled. Any fixed clean space will have a leakage rate of 1% to 2% by volume. Is this leak terrible? Not.
7. Test the remaining variables:
Various factors awaiting consideration include:
Humidity: Due to the strong current of wind in the clean room, a huge electrostatic charge is created. At a time when the roof and partitions have a high electrostatic charge and the space has a low relative humidity, airborne particles will bond with the surface. The moment the relative humidity of the space expands, the electrostatic charge is released and all trapped particles are discharged in a short period, causing the clean space to leave details. High electrostatic charge can also damage sensitive electrostatic discharge materials. It is vital to keep the relative humidity of the room high enough to reduce electrostatic energy. RH or 45% + 5% is considered the ideal tackiness level.
IEST Standard #IEST-WG-CC006 provides requirements for wind flow laminarity.

Comments
Post a Comment